Maxim ADC issued a new generation, ie MAX154 ADC which has a 4-channel input with a resolution of 8 bits, while the MAX 158 has 8 channels with a resolution of 8 bits. This chip is very compact because it is an internal pulse source, compare with ADC0808 which requires an external pulse source using [...]
Sponsored Link :
Article2
ANALOG TO DIGITAL CONVERSION PROCESS
The goal of the ADC process is to accurately represent analog signals as digital signals. Toward this end, three signal processing procedures, sampling, quantization, and encoding, described in the previous sectionmust be combined together. Before the ADC process takes place, we first need to convert a physical signal into an electrical signal with the help [...]
Article3
Digital-to-Analog Conversion in AVR Atmel atmega16
Once a signal is acquired to a digital system with the help of the ADC process and has been processed, frequently, the processed signal is converted back to another analog signal. A simple example of such a conversion occurs in digital audio processing. Human voice is converted to a digital signal, modified, processed, and converted [...]
Article4
ADC in ATMega 8535
A single conversion is started by writing a logical one to the ADC Start Conversion bit, ADSC. This bit stays high as long as the conversion is in progress and will be cleared by hardware when the conversion is completed. If a different data channel is selected while a conversion is in progress, the ADC [...]
Article5
Analog to Digital Converter (ADC) in AVR ATMega 8535
• 10-bit Resolution • 0.5 LSB Integral Non-linearity • ±2 LSB Absolute Accuracy • 65 – 260 ?s Conversion Time • Up to 15 kSPS at Maximum Resolution • 8 Multiplexed Single Ended Input Channels • 7 Differential Input Channels • 2 Differential Input Channels with Optional Gain of 10x and 200x(1) • Optional Left [...]
Article6
Analog to Digital Converter (ADC) on ATMega8535
ATmega8535 provides the ADC with a resolution of 10 bits. ADC is connected to 8 channel Analog Multiplexer which allows formed eight single-ended input voltage is ADC0 to ADC7. Can also be configured into seven differential input channels with ADC1 as the common terminal and the other negative as a positive voltage input. Or a [...]
Article7
PPI 8255 for DAC
Following figure represents the general format of the DAC, where the input is 8 bits or more, and the output of analog signals, which are usually obtained from an op-amp circuit. There are 3 modes of operation in 8255 PIO which can be selected via software that is: Mode 0: Basic input / output Mode [...]
Article8
analog to digital ADC 0804
ADC ADC 0804 is the cheapest, because it only has 1 analog input units. ADC circuit through the parallel port is shown in Figure below. Exposure to computer data through the data pins D0-D7. Status were used as a signal ERROR is used by the ADC pin 5 is INTR ‘. Two control signals are [...]
Article9
ADC 0808
Example 8-bit ADC IC capable of receiving 8 input and widely used is the 0808 ADC ADC although more expensive than 0804. This ADC can be programmed to start other than conversion via pin SC (Start Conversion), can also walk in free running mode, meaning that he will continue to convert the incoming signal input [...]
Article10
Data converters (ADC / DAC) : PCF8591
PCF8591 is AD / DA converter 8 bits with 4 analog inputs using the I2C interface. This chip has been busy replacing the currently used ADC / DAC as standard 0808.0809, MC1408 and 0804. DT51 I2C Adda is Analog Input Output Add-on board for the DT51 using I2C-bus technology, where the main IC used is [...]
